daniel_reetz wrote:Hmm, we could probably add some kind of friction device to the cradle without a loss of functionality - just a little peg or screw that would lightly touch the surface of the bearing area to keep it from rolling.
daniel_reetz wrote:If you have time, could you also comment briefly on how it was to use Rob's shopbot files to cut the part (if that's what you did?)?
ssmdiy wrote:Re the book moving during page turns. The problem isn't the platen rolling but rather the book sliding ever so gently backward if I (by mistake) push it during the page turn. See my picture below. As you see I've got this ruler clamped on to keep the book from sliding. Of course it doesn't work if the clamp is thicker than the pages because then the clamp will hit the glass. That's the problem I'm trying to solve.
Users browsing this forum: No registered users and 3 guests