Fab52 wrote:The viewfinder have to be turn off and on after each capture but I can leave it off and continue to capture...
Fab52 wrote:I was unable to save the capture in raw or fine jpeg no matter if I change the setting the capture have been saved in basic jpeg (440kb instead of 4.5mb and no raw capture).
Fab52 wrote:It take a long time to load the photos (8 frames take a minute) at the start of the app.
Fab52 wrote:There is a lot of infos (84 lines) under the tab "Capture Setting" difficult to figure out ... What we need there should be the basic infos of our capture setting... I think we have all the menu of the d90 under this tab
Thanks for the testing -- it's great that its at least capturing images and downloading them on the D90.
I've added code to switch the viewfinder off before shooting and then back on again so that will be in the next release.
I'll look at why it's being so slow in loading existing images -- 8 x 12MP JPEGs shouldn't take anything like 60secs to thumbnail. I will make it cache thumbnails in any case but that's too slow for normal shooting.
Gerard wrote:this is what i've used for chdk camera control,
a small warning when you start with chdk
- there are a lot of race condition
- memory on this cameras is small, scripts fail often due to memory shortage
tkr wrote:Is the liveview code that you list, specific to the A640, or will it run on my A480 as well ?
Users browsing this forum: No registered users and 1 guest