scantailor-cli How to set image size.

[elviejo]

I'm using scantailor-cli to process images one by one.
the problem with this approach is that, in the end all images
end up being of different size. since the size is proportional
to the content box that was found.

However I do know that all this images should in fact be the same size
at the end
Is there a configuration option to set the final size of the image?

For reference this is the command line I'm using:

Code: Select all

scantailor-cli -v    \
--layout=1.5  \
--dpi=264  \
--output-dpi=200  \
--content-detection=109x267:1482x2134  \
--margins-top=5  \
--margins-bottom=5  \
--margins-left=10  \
--margins-right=10  \
--alignment-horizontal=center  \
--alignment-vertical=top \
--threshold=9 \
/home/agarcia/Dropbox/Camera\ Uploads/10-waitingScanTailor/$imagefile \
/home/agarcia/Dropbox/Camera\ Uploads/20-waitingOCR/


[pejuko]

To keep same size for all images you need either process them all togather or try use --content-box=109x267:1482x2134 parameter instead of --content-detection (this parameter is for something else ).